Kayak Quickstart

Roll out your kayak. Find the 3 inflation valves.

Press down and release the valves to be in the up or inflation position.

While in the up/inflation position no air will escape the valves.

Insert the pump into the valves.

Twist the pump valve to lock into place.

Inflate the all of the chambers to 13PSI.

Remove the pump by twisting, then screw the cover onto the valves to prevent opening the valves and releasing air.

Flip the kayak over and slide the center fin into its track.

Slide the lock through the slots on the fin and kayak.

Push down on the locking button and insert into the middle part of the paddle.

Insert the other paddle blade into the middle part of the paddle. Close the lock when the paddle is at comfortable length.

If the paddle handle feels loose, tighten the hinge by rotating the latch clockwise.

Make sure the drain plug at the front of the kayak is secure. This can be removed when finished paddling to drain water from the kayak.

Setup the footrest to the front D-rings. Tighten to personal prefrence.

Setup the seat between the four D-rings in the center of the Kayak. Fasten down the seat so there is minimal movement.

Clean any dirt, sand, mud, etc.. from equipment

Unlock the center fin, unscrew the valve cover(s) and press the valve(s) down to deflate.

Tightly roll up the kayak and slide it into the bag. The pump and paddle are stored inside the locker.